1.1 This specification covers the basic properties of thermoset molding compounds and the test methods used to establish the properties.
1.2 Classification – Molding thermosetting plastic compounds shall be of the following resins and are covered by the individual specification sheets (see 5.1 and Annex A1-Annex A8).
|
Resin |
|
Phenolic, cellulose filled |
|
Phenolic, mineral/glass filled |
|
Melamine |
|
Polyester |
|
Diallyl iso-phthalate |
|
Diallyl ortho-phthalate |
|
Silicone |
|
Epoxy |
1.3 Order of Precedence – In the event of a conflict between the text of this specification and the references cited in Section 2 (except for related specification sheets), the text of this specification takes precedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
1.4 The values stated in SI units are to be considered standard.
